![]() Go to Target → Click on “Program” make sure “reset after programming” is toggled on and click “Start”Ĭtrl + D will safely disconnect the BluePill. Press and hold the “reset” button on the blue pill. In Target → Settings, Make sure “Hardware reset” and “Connect under reset” are set from the drop down manus. ![]() Windows Install the ST-Link Utility Driversĭownload here → Install the ST-Link Utility Programmerĭownload here → Bootloader Flash (Windows) Mv m_star_classic ~/qmk_firmware/keyboardsĮven if you do all the steps correctly, without being in the dialout group you will not have the correct permissions. I put mine in ~/ but if you want it somewhere else, just remember for future commands where you put it. Ubuntu and similar flavors should be the same as what I’m doing. Commands/setup may vary depending on your distro. You will still probably use linux for QMK, but the bootloader is much easier on Windows.įor the guide I put the. bin file that has the stm32duino bootloader configuration. ![]() Whether or not you use Windows or Linux, you will need the. You can order your own, or you can buy the replacement kit from Level1Techs that comes with a pre-flashed BluePill and a PCB with surface mounts ready a for model M.bin Bootloader File
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |